GripEdge | Ultimate G-FORS Socket Extractor Bundle | Buy XBM10S & XCM7S Get XAM9S Free

Buy 2, Get 1 Free: The Complete G-FORS Socket Extractor Bundle

Fastener failure is a geometry problem. Once a hex head rounds past its flats, a standard six-point socket has nothing left to engage, and a tapered extractor only bites at its widest point before it cams out and polishes the head smooth. This bundle solves that across the full working range. Pair the XBM10S 10-Pc 3/8" Drive Metric set with the XCM7S 7-Pc 1/2" Drive Metric set, and the XAM9S 9-Pc 1/4" Drive Metric set ships free. Together they deliver continuous metric coverage from 4mm through 25mm across all three common drive sizes, with a single extraction principle behind every socket.

Each set is built on the same patented G-FORS™ geometry, so engagement behavior is identical whether you are removing a 6mm socket cap screw or a 24mm lug nut. Nothing in the lineup is a compromise piece.

What's in the bundle

• XBM10S: 10-Pc 3/8" Drive Metric — Sizes 10-19mm. The primary-range set covering the bolt and stud sizes most engine, chassis, and drivetrain work lives in.
• XCM7S: 7-Pc 1/2" Drive Metric — Sizes 19-25mm. Heavier-wall sockets rated for the higher breakaway torque of large, corroded, or seized fasteners.
• XAM9S: 9-Pc 1/4" Drive Metric (FREE) — Sizes 4-12mm. The small-fastener range for tight-access and low-torque applications where control matters more than mass.

The engineering behind the grip

• Straight-cut, non-tapered bore. Where tapered extractors contact the fastener at a narrow band and wedge material outward, the G-FORS™ profile is cut straight so its grooves make full-length contact along the fastener sidewall. Load distributes over the entire engagement depth rather than a single point, and the geometry pulls material inward to increase bite as torque rises. The result is reliable purchase on fasteners rounded up to 100%.
• Integrated G-FORS™ pusher rod. Extraction is only half the job; clearing the socket is the other half. Thread the pusher rod through the rear of the extractor and the extracted stud, bolt, or screw drives straight out. No bench vice, no hammer and punch, no risk to the socket's internal geometry.
• Bi-directional engagement. The profile grips on both left and right-hand threads, which lets you work a seized fastener back and forth to break the corrosion bond before final removal. A compromised fastener can also be reinstalled temporarily when a replacement is not on hand.
• Material and finish. Premium Cr-Mo steel construction for the strength and fatigue resistance required under impact, a corrosion-resistant coating, and laser-marked sizing for legibility in low light. Every socket is hand and impact ready.

Two sets, three drive sizes, one free, and one extraction principle from the smallest grease nipple to the most stubborn lug lock. When others fail, GRIP IT.

For a full breakdown of the extraction geometry, see our G-FORS™ Technology page.